EBS EBS 2600, User Manual

Page: 25 / 184

25 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
3. Make drip system 3 and waste bottle 3a ready for fasten-
ing to support beam 8 .
Before drip system 3 is installed, you must remove
the plugs from the tubes that are part of the sys -
tem.
While positioning the drip system, you should take
into consideration the length of the tubes that are
part of drip system 3 .
Fig. 11.
8a
8a
3
3a
4. Put support beam 8 in clamp holders 8a and in the holder
of drip system 3d , inserting it according to Fig. 12 . Use
the # 5 angle hex key to tighten the appropriate screws
that are part of clamp holders 8a and 3d , clamping
the holders to support beam 8 .
Fig. 12.
8
1x
5
1x
5
8a
3d
8a
5. Fasten printer beam 9 and articulated holder 9a to support beam 8 (see Fig. 13 ). Use # 5 angle
hex key to tighten the appropriate screw that is part of holder 9a , clamping the holder to support
beam 8 .
Articulated holder 9a can be configured in 3 ways. For more details see “2.3. Installing the Printer”
“2.3.1. Additional Information” .
9b
1x
5
9a
Fig. 13.
8
9
1x 5
While installing the printer make sure that holder fins 9b (see Fig. 13 ) are properly put into the ver -
tical grooves on the beams.