EBS EBS 2600, User Manual

Page: 24 / 184

24 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
There are many potential configurations of the printer on a factory conveyor,
therefore the description given in this chapter applies to the configuration given in the following ex -
ample. Actual or optional components may differ from those depicted in illustrations. For information
about optional accessories contact an authorized representative of
EBS Ink Jet Systeme GmbH .
Before you start installing your printer, read carefully the information that is given at the be -
ginning of this chapter and in The Safety Instructions .
To install the printer:
Tools required:
‑ a # 5 angle hex (Allen) key,
‑ a # 3 hex (Allen) key with a ball tip,
‑ a # 7 open ended spanner (optionally; for changing the position of articulated holder 9a ),
‑ a cross head screwdriver,
‑ a drilling machine.
1. Prepare appropriate mounting holes in the conveyor frame (see Fig. 10 ).
NOTE: Firm fastening is required!
Adjust the installation to the existing technical conditions to ensure that the printer is steadily
fastened to the conveyor.
Never tilt the printer away from the vertical direction (to any side) through an angle greater than
30° while performing all installation operations and while using the printer.
Assort distance L (see Fig. 10 ) depending on the amount of free space available on the conveyor
and on the layout of printer components on printer support beam 8 .
2. Fasten clamp holders 8a to the belt conveyor and position them according to Fig. 10 . Tighten
the screws in holders 8a with the # 3 hex key with a ball tip.
8a
3 2 mm
3 2 mm
3
2
m
m
3
2
m
m
L
4 x M4 holes
4 x M4 holes
Fig. 10.
4x
3
8a
4x
3