EBS EBS 2600, User Manual

Page: 150 / 184

150 of 184
EN
EBS‑2600 User Man
ual
G2023/04/26_1EN 2023.05.16
2. Use the cross head screwdriver to loosen two screws 5d (see Fig. 62 ) that fasten slide 5 .
INK-JET EBS-2600/510/72
P120425000-101234
2022
Type
Typ
Number
Nummer
Manufactured
Baujahr
Made in EU
50 - 60 Hz
< 0.5 A
100 – 240 V Voltage
Spannung
Frequency
Frequenz
Current
Stromaufnahme
Fig. 62.
2
3b
5
5c
2x
5d
3a
3. Remove slide 5 .
4. Use the sprayer to spray wash‑up over the nozzle plate.
5. In place of the removed slide
5 install drip molding 5c .
6. Use the cross head screwdriver to tighten two screws 5d to fasten drip molding 5c .
If the long purging/venting procedure is followed, it may be necessary to put absorbent material or
a metal vessel under the printhead because the drop system may be incapable of receiving the en -
tire ink flowing out of the nozzles during the procedure.
To prepare the printer for the printhead purging/venting procedure without the use of an optional drip
molding :
1. If the printer is printing, press the icon on menu bar C (see Fig. 43 on page 52 ) on the main
screen to pause printing.
2. Use the sprayer to spray wash‑up over the nozzle plate.
3. Secure the printhead's ink outlet (the nozzle plate) with absorbent material.
To start short purging/venting of the printhead:
1. Press and hold the icon on menu bar C (see Fig. 43 on page 52 ) on the main screen,
and when a drop‑down menu occurs press Purge