CPX220NWB ALARM CONTROL UNIT – INSTALLER MANUAL
31 / 123
<XX> <Y>
Remote controllers configuration
<XX> <Y>
Emergency buttons
4.3.1.
Installer code
The installer code can be changed here. 3 beeps will confirm the successfully entered
function.
<Installer code>
<Installer code>
where:
Installer code –
new installer code (from 4 to 7 digits)
You can press
any time to exit without saving changes.
4.3.2.
Power loss
The function determines time in seconds after which failure is to be reported. The function’s
argument is of decimal type. 3 beeps will confirm the successfully entered function.
To change /configure the time:
<Time>
where:
Time –
time in seconds
You can press
any time to exit without saving changes.
4.3.3.
Reset to default settings
That function resets the settings to their default configuration, accessible from the service
mode level. Additionally, the function sets the default output options and default installer
code. The wireless detectors and remote controls are not deleted.
In order to protect the settings against accidental modification, the function is to be
confirmed with installer code. 3 beeps will confirm the successfully entered function. Using
that function will trigger the control unit’s reset using default parameters.
<Installer code>
You can press
any time to exit without saving changes.
4.3.4.
System options
That function allow to switch on and switch off additional options of the system. The
argument of the function is BIT type. By pressing 1, 2, 3, 4, 5 and 6 keys, you can switch
on/off proper option. 3 beeps will confirm the successfully entered function.
<Options>
Where:
Options
– number of option (BIT type parameter):
