EBS Active Track, Operation & Maintenance Manual

Page: 21 / 79

21 First steps
© 2013 EBS
 no connection to monitoring station
Note:
The device goes back from sleep into work mode when main battery voltage
level is good enough and after pressing any of the buttons located on the devices's
casing.
9 Configuration
After powering-up properly configured device, it automatically connects to the
receiver of monitoring system (e.g. OSM.2007). No further action required.
There are two configuration methods:
 with SMS commands, containing data required for establishing connection with the
monitoring system receiver, see chapter
Remote configuration ,

with GPRS transmitters configuration programme, establishing connection with
the device through appropriate RS232 cable or using GPRS connection, see chapter
Configuration program .
Only the second method permits access to all programmable parameters of the
device. Nevertheless, in order to use a GPRS connection using this method (e.g. when
programming cable is not available) the device should first connect with the
monitoring system receiver using the first method (SMS configuration).
Remote configuration
Configuration of Active Track device consists in sending SMS message to the
device or using GPRS (e.g. using OSM.2007 monitoring receiver). These steps enables
connection to server and makes all device function available.
21
27