Receiver - Plug-In Dimmer Module
Ref : RPL
July 2009
page 7
RPL
To reset all lamp module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Tips
- Knowledge base available on
www.ebodeelectronics.eu
.
Can I plug RPL module into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
Operating the RPL Module
I’m using a X10 compatible wireless remote, e.g. TPC, IMRF, EM, SS13,
KR22, SH600 or HR10, but the RPL is not responding?
-
Check and/or change remote control batteries.
- Check if your transceiver is correctly connected.
RF Transmitter = RPT, RMA, RMV, TM13, CM15 or SC28 security console
IR Transmitter = IR7243 along with the remote control
-
Reset the RPL (see paragraph 3) then reprogram the address.
- Then, proceed again using learning mode as explained in 2.)
The RPT does not respond to command sent via the power line?
- Reset the RPL (see paragraph 3) then initialize the address.
- Then, proceed again using learning mode as explained in 2.
Functions enabled by a wireless transmitter (EM, TPC, IMRF, etc..)
ON / OFF key
Turns the lamp On & Off