Receiver - Plug-In Appliance Module
Ref : RPA
July 2009
page 7
RPA
Reset appliance module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Tips
- Knowledge base available on
www.ebodeelectronics.eu
.
Can I plug appliance receiver into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
The RPA does not respond to command sent via the power line?
Reset the RPA (see paragraph 3) then initialize the address.
I’m using a X10 compatible wireless remote, e.g. TPC, IMRF, EM, SS13,
KR22, SH600 or HR10, but the RPA is not responding?
-
Check and/or change remote control battery.
-
Check if your transceiver is correctly connected.
-
Reset the RPA (see paragraph 3) then reprogram the address.
Operating the RPA module
Gently press the upper key (ON) on i.e. EM, TPC, to turn on the appliance/light.
Gently press the lower key (OFF) on i.e. EM, TPC, to turn of the appliance/light.
