QUBO
EN
28
www.eberg.eu
1. Turn the pipe in the direction of the arrow (1) in the figure below and connect it to the
device.
2. Turn the pipe in the direction of the arrow (2) in the figure below to disconnect the cable.
When operating in heating mode:
Disconnect the blow shield and heat conduit in the direction indicated by the arrows in Fig. 1.
Then these parts should be replaced (Fig. 2) and installed opposite to the output condition
(Fig. 3).
EXHAUST HOSE INSTALL
CHANGE OF MODES HEATING / COOLING
1
2
3
