FAN SPEED AND TEMPERATURE SETTING
The fan has a built-in speed and temperature control module and an external temperature sensor with a length of
4 m and a power cable with a European plug.
The algorithm of work according to temperature indications, in range of 20-35°C.
When the indoor temperature will be too high, the controller will accelerate the fan speed.
When the temperature stabilizes at the desired level, the fan will return to the previously set revolutions.
STARTING UP
Before starting up the machine, make sure that:
•
The appliance is well secured and the electrical connections have been carried out correctly.
•
No loose material or fitting remains can be sucked up by the ventilator, If the ventilator has been mounted in a
duct, make sure it is clear of loose material.
•
The earth fittings are adequately connected.
•
The electrical safety devices are correctly connected, adjusted and ready for use.
•
The wire and electrical connections inputs are correctly sealed and water-tight.
When starting up the machine, make sure that:
•
The propeller turns in the correct direction.
•
There are no abnormal vibrations.
•
If any of the electrical safety devices blow, the apparatus must be quickly disconnected from the mains supply.
The whole installation should be carefully checked before trying to start up the machine again.
MAINTENANCE
•
Before manipulating the ventilator, make sure it is disconnected from the mains supply even if it has previously
been switched off. Prevent the possibility of anyone else connecting it while it is being manipulated.
•
The appliance must be regularly inspected. These inspections should be carried out bearing in mind the
machine is working conditions, in order to avoid dirt or dust accumulating on the propeller, turbine, motor or
grids. This could be dangerous and perceptibly shorten the working life of the ventilator unit.
•
While cleaning, great care should be taken not to unstable the propeller or turbine.
•
All maintenance and repair work should be carried out in strict compliance with each country is current safety
regulations.
9
EN
