EBENCH KH 2027, Operating Manual

Page: 24 / 29

The automatic repeat alarm is adjusted
individually by 1-59 minutes. When the
device is switched off, and the date and
time alternatively or just the time appear
in the display:
Press the MODE button until SNO 10 or
just the time appears in the display.
Press the TUNING button to set the
repeat alarm time minute-wise.
Press the MODE button again. The
repeat alarm time is now saved.
However, if you want to switch off the
alarm function
completely , that can only
be done as described in section 8g.
Note: The set alarm and time are erased if
the device is without power for more than
30 seconds, e.g. while changing batteries.
Be sure to check all configured times after-
ward!
i) Date Alarm (SDA)
You can program a reminder alarm to go
off on a specific date. On this day, an alarm
will go off for about 10 minutes at every
hour starting at 8:00 a.m. until you press
any key. It can be programmed for up to
10 reminder alarms. The reminder alarms
1-10 can be selected via the button
PAGE
When the device is switched off, and the
date and time alternatively or just the time
appear in the display:
Press the MODE button until the date
blinks in alternation with SDA in the
display.
Press one of the TUNING buttons briefly
to set the SDA date by day .
Hold one of the TUNING buttons pressed
to change the SDA date in 10-day steps .
Press the PAGE button to go to the next
reminder alarm
KH 2027 KH 2028
- 20 -
KH2027_2028_IB_UK_V6 20.02.2006 9:44 Uhr Seite 20