1
2
3
4
5
6
7
8
9
10
Use the 1m USB charging
cable to charge your Edge+
Stylus with any USB
power adapter.
Once fully charged, your
stylus can be used
continuously for up to
15 hours.
Connect the micro USB
cable to your Edge+ Sensor.
Connect your projector
to your computer.
Turn on your projector and
align/focus the image on
the projected surface.
Place a mounting plate
onto the back of the sensor
with the Command
adhesive side facing out.
*(See note for magnetic
mounting option)
Peel the Command adhesive
backing from the sensor.
*Note:
You also can place
the sensor directly onto
magnetic surfaces without
using the plate.
Hold the sensor and
prepare to place it carefully
in the indicated location.
Allow a 5cm margin
between the sensor and
writing area.
Place the sensor so that it
is centered vertically on the
projected surface, parallel
to the projection edge.
Connect the Edge+ USB
cable to your computer’s
USB port. Install and run the
eBeam software.
Download at:
http://www.e-beam.com/
portal/download-software.html
After the eBeam software is
launched, calibrate the system.
Congratulations!
Your eBeam Edge+ system is
now ready for use.