900
860
840
560
560
STEP 2:
Pre-assemble rear and side wall panels.
Overlap sheet 18 (fig2.1) by
two full sheet ridges
over sheet 2
. Next overlap sheet 1 (fig2.1) by
one full sheet ridge
over sheet 18 (
making sure that the side with pre-drilled holes are atop
) on your
work table/ground (fig2.2) and join them together with self tapping screws. You will need to
make sure the two ends are held firmly together so that the screw penetrates both sheets.
Now fit top channel 23 and bottom channel 22 to the sheeting and firmly hold both sheets and
channel together and screw into pre-drilled holes.
23
22
1
18
2
NOTE:
The top and bottom screws to be fixed only after
attaching channels.
fig2.2
2
18
fig2.1
You may find it easier to assemble your shed using sawhorses with timber planks attached
especially if you are working alone. The planks need to be almost the same length as the shed
you have bought or alternatively make use of a trestle table. Be careful when handling your sheets
as sharp objects can easily scratch the paint.
6.
Supplied by
building the future together
building the future together
DURO
Note that the large inner stiffer lip of the channel is always facing
toward the rear-side of the sheet. When the walls are stood upright
the lip will be on the interior and you should be looking at the
shorter wall of the channel on the outside (fig2.3).
fig2.3
Outside
Inside
Lip
Shorter Side
Shorter Side
