a 6mm Allen wrench, remove the flat head screw from the threaded point that
will be used for locking the angle.
c.
The MKD Series Loudspeaker may have weather-protected fiberglass shell which
increases the size of the loudspeaker. There are multiple sized rubber washers (E and F)
included with the MKD Series U-Bracket to accommodate the larger loudspeaker size.
Select the rubber washer to best fill the gap between the loudspeaker and u-bracket for
use equally on both sides of the loudspeaker.
d.
Installing the MKD Series Loudspeaker onto a mounted MKD Series U-Bracket.
i.
WARNING: Take care when handling and wear PPE gloves to protect from
crushing and impacts with digits, limbs, and/or product.
ii.
Note, for weather protected applications (using MKD-WP Series Loudspeakers),
apply user-supplied, waterproof, non-hardening, non-locking thread sealant to
the threads of two button head screws (B)
per the thread sealant’s instructions
.
Failure to do so could result in water ingress and damage to the loudspeaker.
iii.
Onto each of two button head screws (B), place a lock washer (C) and a flat
washer (D).
iv.
WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT
–
Lift the MKD Series
Loudspeaker to align the
loudspeaker’s center threaded mounting hole with the
MKD Series U-Bracket preferred mounting point.
v.
Using a 6mm Allen wrench, loosely thread the screws and washers (B, C & D)
through the MKD Series U-Bracket mounting point, through the selected rubber
washer (E or F)
and into the loudspeaker’s center threaded mounting hole
.
Repeat for the opposite side.
vi.
If using the MKD Series U-
bracket’s slotted mounting point “A”
, the hardware
may be preassembled to the MKD Series Loudspeaker.
1.
Note, if using the slotted mounting point, the MKD Series U-Bracket must
be installed oriented with the slot angled upward, opposing the ground.
2.
Note, for weather protected applications (using MKD-WP Series
Loudspeakers), apply user-supplied, waterproof, non-hardening, non-
locking thread sealant to the threads of two button head screws (B) per
the thread sealant’s instructions. Failure to do so could result in water
ingress and damage to the loudspeaker.
3.
Onto each of two button head screws (B), place a lock washer (C), a flat
washer (D) and the selected rubber washer (E or F). Thread these screws
and related hardware three complete turns
into the loudspeaker’s
two
center threaded mounting holes.
4.
Leave as large a space as possible between the rubber washer (E or F) and
the flat washer (D).
5.
WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT
–
Lift the MKD Series
Loudspeaker into the MKD Series U-bracket slots with the large rubber
washers (E) inside the u-bracket and the flat and lock washers (C & D)
outside the u-bracket.
vii.
Position the MKD Series Loudspeaker to the desired angle.
