6.4.3
Hinge and Hinge Tube Holes
DANGER: Ensure each Quick Release Pin used in assembling an array is fully inserted and
engaged into the Hinge Tubes and Hinge holes. Only use the Quick Release Pins supplied or
equal. Pins of different lengths, diameter, or materials will compromise the structural integrity of
the rigging system and may result in damage to the equipment, injury, or death.
The Hinges and Hinge Tubes,
located on four corners of each
enclosure, have several holes for
inserting the Quick Release Pins
to attach enclosures together or to
the Fly-Bar. The particular holes
used will determine the splay
angles between the loudspeaker
aiming axes. The rear splays
required for these splay angles
and the Hinge and Hinge Tube
Holes to use to achieve them are
designated by Resolution.
KF740 to Fly-Bar
Rear Hinge Hole
Rear Hinge Tube Hole
Front Hinge Hole
Front Hinge Tube Hole
0° 2B 1A Upper
3.0° 2A
1A Upper
6.0° 3A
1A Upper
KF740 to KF740
1
Front Splay Angle
Rear Hinge Hole
Rear Hinge Tube Hole
Front Hinge Hole
1.5° 1
A
2
3.0° 2
B
2
6.0° 2
A
2
9.0° 3
A
2
12.0° 4
B
2
18.0°
2
4 B 1
NOTES:
1.
T
he front splay angle is the between the aiming axes, not the top/bottom enclosure surfaces.
2. A front splay angle of 18.0° requires two additional Quick Release Pins not supplied with the
KF740. Please contact an EAW dealer to obtain additional Pins.
Page 14 of 22 KF740 OWNER’S MANUAL
