If you have questions about these instructions or about suspending or arraying more than two (2) JFX Series
loudspeakers please contact the EAW Application Support Group:
Tel
800-992-5013 (USA only)
Tel
508-234-6158
Fax 508-234-8251
E-mail [email protected]
Thank you for purchasing
EAW products
One Main Street, Whitinsville, MA 01588 tel 800 992 5013 / 508 234 6158 fax 508 234 8251 web www.eaw.com
T h e L a w s o f P h y s i c s | T h e A r t o f L i s t e n i n g
EAW is the worldwide technological and market leader in the design and manufacture of high-performance, professional loudspeaker systems.
4. Ensure that the brackets
lay flat against the rear of
both enclosures and the
enclosure sides are parallel.
Then, snugly tighten all the
bolts so that each lock
washer is properly engaged.
1. Remove the top
and bottom 3/8-16
mounting bolts
from the rear of each
enclosure.
EAW P/N 0005915 (A)
Installation:
The Splay Brackets can be installed before or after the loudspeaker array is suspended or mounted.
Avoid subjecting the bracket to excessive torque or bending loads that could deform the bracket and result in
improper splay angles. There is only ONE correct way a Splay Bracket can be installed. The end with the short bend
MUST be to the left.
NOTE:
All left/right references are looking at the rear of the upright loudspeakers.
ARRAYING TWO LOUDSPEAKERS
2. Fasten both brackets (short
bend toward the left) to the
left-most enclosure in the
array with the supplied bracket
bolts, lock and flat washers.
Hand-tighten the bolts.
3. Attach the second enclo-
sure and hand-tighten the
supplied bolt assemblies.
Summary of Contents for JFX Suspension Kit
Page 3: ......
