12
– CIS120
7. OPTIONAL KITS
Two kits are available for the CIS120. One is a mounting
kit, and one is a trim ring kit. Please contact your dealer or
EAW Commercial for ordering details.
AC-CK cable mounting kit
This kit consists of four 10-meter lengths of wire rope
with a crimped-on hook at one end. A small locking device
allows the length to be easily adjusted, so you can hang
the CIS120 accurately in position in a suspended ceiling,
for leveling, or setting at an angle.
1. Find the location where you want the loudspeaker
to be suspended.
2. Use suitable flying points above the loudspeaker.
These may be ceiling beams or suitable eyebolt
hardware. (The dimensioned drawing at the bottom
of page 10 shows the location of the eyebolts.)
3. Pass the free end of each cable over the support
beam/structure and loop it through the hook/latch.
4. Pull on the free ends to take up the slack and thus
secure the hook/latch assemblies.
5.
Note:
The hexagonal locking
device has an arrow engraved on
one side. This must be pointing
down
when installing.
You will need an assistant to help
hold the loudspeaker in position
and support its weight.
Pass the free end of the wire through the outside
hole of the top end of a hexagonal locking device,
through a loudspeaker eyebolt, and back up
through the center hole of the locking device.
Fitting the hook/latch
to a support
CIS120 suspended by four
wires
Fitting the wire to an eyebolt
Close-up view of the
hexagonal locking
device
