Eaton XV100, Manual

Page: 25 / 80

5 Installation
5.1 Safety regulations
Touch display XV-102 10/2020 MN04802004Z-EN Eaton.com
23
5 Installation
5.1 Safety regulations
5.2 Prerequisites for the location of use

Approvals:
The device must be used exclusively in locations for which it has been approved/certified. See the
markings on the nameplate and Chapter 9 Technical data,

65.

Power supply:
The power supply must comply with the requirements stated in Chapter 9.5.1 Power supply,

71.
5.2.1 Engineering conditions of acceptability by Underwriters Laboratories Inc. (UL)
For the approval in accordance with the standard UL 508, consideration must be given to the following:

Ambient conditions:

Max. ambient air temperature: 50°C

Degree of pollution 2

The screw terminals of the connector for the power supply must be tightened with a max. tightening
torque of 0.6…0.8 Nm or 5…7 Lb. In.

Only XV-102-BE-…- and XV-102-E… devices:
The SmartWire-DT master interface's U
Aux
supply voltage must be externally protected against
overcurrent and short-circuits with the following:

Miniature circuit-breaker 24 VDC, rated operational current 2 A, tripping characteristic Z

Or a 2 A fuse
5.2.2 Conditions for marine approval (DNV GL)
The following DNV GL rules for shipping classification in accordance with DNVGL-CG-0339 type
approvals must be observed:
1 Complete and proper installation and commissioning in accordance with DNV GL rules and Eaton
requirements and specifications.
2 Installation of radio interference suppression filters for the 24 V DC supply.
3 Screening the communication cables used.

Read Chapter 3 Safety regulations,

13 before installing and commissioning the de-
vice. This contains important information for your personal safety.

2.7 Marine approvals,

12
5.3.3 Section Radio interference suppression filter for the 24 V DC
supply,

31
5.4.2 Screening the communication cables used,
 54