Eaton xStorage 400, Installation And Operation Manual

Page: 42 / 96

32 Eaton xStorage 400 Installation and Operation Manual P-164001032—Rev 01
Table 6. Control and Monitoring Panel Interface Wiring
Connection Start Connection End Cable Conduit Comment
EAC Service Port EAC ENET1 Cat6e Ethernet Conduit 1
EAI Service Port EAI Service Port DB9 Cable Conduit 1
EAI ON Button EAI Terminal Block
TB3-9 and TB3-10 Twisted Pair #14 Conduit 1 Inverter Startup Control
EAI OFF Button EAI Terminal Block
TB3-7 and TB3-8 Twisted Pair #14 Conduit 1 Inverter Shutdown control
BESS PM Ethernet Port EAC P4 Cat6e Ethernet Cable Conduit 1 BESS PM Communication
with EAC
Site Input PM Ethernet
Port EAC P5 Cat6e Ethernet Cable Conduit 1 Site PM Communication with
EAC
BESS PM RS485+ EAI TBC-1
Twisted Shielded
Pair #22
Conduit 1
RS-485 +
BESS PM RS485- EAI TBC-2 RS-485 -
BESS PM RS485 SH EAI TBC-3 RS-485 Shield
Site Input Meter
Shorting Block (SBB) Switchgear CT’s 8/C #12 Conduit 2 Site Input Meter CTs
Circuit Breaker
CBCMPB Switchgear PT’s 4/C #12 Conduit 2 Site Input Meter PTs
BESS Meter Shorting
Block (SBA) BESSD Loadside
CT’s 8/C #12 Conduit 3 BESS Meter CTs
Circuit Breaker
CBCMPA BESSD Loadside
PT’s 4/C #12 Conduit 3 BESS Meter PTs
• Power cables will run from the BESS Disconnect in the switchgear to the EAI.
• Control wires and Ethernet cables will have to run to the EAI and connected to the Aux box, EAC, and EAI
Service port.
• Wiring will go through conduit out of the CMP.
• The control cable conduit will enter through the bottom conduit entrance (similar to power cabling).
• Cables will then have to route to the terminal block, service port, EAC, and Aux Box.
Installing Interface Wiring Connections