6 Operation
6.2 Starting the device
58
MICRO PANEL XP-702
07/2011 MN04802003Z-EN
www.eaton.com
6.2
Starting the device
Requirement:
The CF card with the operating system is located in the CF slot 0
or the hard disk with the operating system is mounted in the device.
Procedure:
1
Energize the device.
The device will boot.
2
If the device does not boot up and/or if an error message appears while starting (booting) the
device, see Chapter 7.4 Troubleshooting,
3
Complete the following steps after initial commissioning
(
→
Document «MN05010008Z-EN System Description Windows XP/XPe»):
3.1
Adjust the system settings of the device.
3.2
Install the required application programs.
6.3
Switching off the device
1
Shut down the operating system.
2
De-energize the device.
Frequent on/off switching of the device, especially at low temperatures, will reduce the
lifespan of the cold cathode tubes (CCFL) of the backlight.
Avoid frequent on/off switching of the device.
To switch on the device again, it must be de-energized and can only be switched on
again after a pause of 20 seconds.
www.comoso.com