Eaton XP-702 Series, Operating Instructions Manual, Page: 51 / 86

5 Installation
5.4 Preparing the device for operation
MICRO PANEL XP-702 07/2011 MN04802003Z-EN www.eaton.com
51
5.4.5 Mounting a device with a display
1 Select the mounting position of the device as described in Chapter 5.2.2 Requirements for the
mounting position,
 30.
2 Prepare a mounting cutout for the device at the selected position:

Mounting cutout:

8.4" devices: 261 × 194 mm (±1 mm)

10.4" devices: 329 × 238 mm (±1 mm)

12.1" devices: 344 × 262 mm (±1 mm)

15" devices: 410 × 315 mm (±1 mm)

Material thickness at the mounting cutout 2…5 mm

The following number of retaining brackets and threaded pins are required for mounting
in accordance with IP65 / NEMA 4X and for use in potentially explosive atmospheres:

8.4", 10.4" and 12.1" devices: 8 pieces each

15" devices: 12 pieces each
If needed, please order additional retaining brackets with threaded pins from your sup-
plier.
Fig. 33 Mounting cutout for 8.4" devices Fig. 34 Mounting cutout for 10.4" devices
Fig. 35 Mounting cutout for 12.1" devices Fig. 36 Mounting cutout for 15" devices
261.0
+1/-1
194.0
+1/-1
329.0
+1/-1
238.0
+1/-1
344.0
+1/-1
262.0
+1/-1
410.0
+1/-1
315.0
+1/-1
www.comoso.com