Eaton XC200 Series, User Manual

Page: 49 / 82

10/10 MN05003004Z-EN
45
5 Establishing a PC – XC100 connection
This section describes the measures that are required to link a PC
to the XC100, so that the PC can be used as a programming device
(hardware and software).
Establishing a connection via the RS232 interface
Communication is implemented via the non-optocoupled serial
RS232 interface. You can use either the COM1 or the COM2 port
for the PC interface. Please use the XT-SUB-D/RJ45 programming
cable to make the physical connection.
Programming cable
The programming cable is made up as shown below:
Software easySoft-CoDeSys
The communication parameters are determined by means of
easySoft-CoDeSys.
X
Call up the menu item ‹Online r Communication Parameters›
in easySoft CoDeSys, and select the COM1 or COM2 interface.
X
Preselect the values indicated in Figure 59.
You can alter the default values by making a double-click on the
entered value.
Communication fault(#0): Logging off
A connection can not be established between the programming PC
and the XC100, please check:
• the physical connection
• the baud rate of the communication parameters in the
easySoft CoDeSys
• the baud rate in the XC100 (set as default to 38400 kBit/s)
• the baud rate of the CAN connection if the CAN fieldbus is used.
• that the interface parameters in the easySoft CoDeSys and in
the XC100 correspond!
RJ45 plugs programming cable SUB D
socket
Figure 58: Pin assignment RS232 programming cable
8
7
6
5
4
3
2
1
5
8
4 2
3
5
3
41
2
5
8
96
7
h Further notes on the communication parameters can be
found in the programming software manual
(MN05010003Z-EN; previously AWB2700-1437GB).
Figure 59: Select communication parameters