112
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Electronic Clutch Actuator (ECA)
|
Removal and Installation
TRSM0940
5.
Remove the ECA.
Note:
The ECA has an alignment pin that requires the
unit to be rotated to exit the Clutch Housing bore.
Note:
If ECA will not slide from the Clutch Housing
after all the fasteners are removed, use the available
pusher holes found on both sides of the ECA casting.
Place the included jackscrews into the holes. Turn each
jackscrew until it touches. Next, turn the upper jack-
screw 1 turn; then rotate the lower jackscrew 1 turn.
Continue until the ECA is fully displaced from the bore.
ECA Installation
1.
Install the ECA into the Clutch Housing bore. Align it
with the lower Cross-Shaft.
Note:
The ECA will have to be rotated to align with the
slot in the Clutch Housing.
Note:
Ensure you rotate the Release Yoke as close to
the Case Dowel in the Clutch Housing prior to mating
with the Cross-Shaft. This allows the Release Yoke to
clear the Release Bearing during installation.
Summary of Contents for UltraShift PLUS
Page 265: ......
