Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01
9
22..33
C
Coonnnneeccttiinngg tthhee IInntteerrnnaall B
Baatttteerryy
NOTE 1
Place the UPS on a flat, stable surface in its final location.
NOTE 2
Always keep 150 mm of free space behind the UPS rear panel.
Figure 6. Internal Battery Connection
2
1
4
3
5
1.
Remove the center cover of the front panel.
2.
Push left cover toward to right direction.
3.
Open the left side of the front panel.
NOTE
A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or
disconnect it.
A small amount of arcing may occur when connecting the internal batteries. This is normal and will not harm
personnel. Connect the cables quickly and firmly.
4.
Connect the two battery connectors together.
5.
Put back the front panel, then clip the center cover.
22..33..11
U
UP
PS
S TToow
weerr IInnssttaallllaattiioonn
Tip
If you ordered other UPS accessories, refer to specific user manuals to check the tower installation with
the UPS.
To install the cabinet:
1.
Place the UPS on a flat, stable surface in its final location.
2.
Always keep 6" or 150 mm of free space behind the UPS rear panel for ventilation.
Summary of Contents for Tripp Lite SmartOnline Series
Page 12: ...6 Tripp Lite by Eaton SmartOnline Series User Guide 614 21325 Rev 01 Rear Panels...
Page 38: ...32 Tripp Lite by Eaton SmartOnline Series User Guide 614 21325 Rev 01 Retrieving the Event Log...
Page 48: ...42 Tripp Lite by Eaton SmartOnline Series User Guide 614 21325 Rev 01 Service and Support...
Page 54: ...614 2132501 614 21325 01...
