Components of the
SmartWire-DT system
19
02/11 MN05006002Z-EN
PCB for surface mounting enclosure M22-I…
The M22-I… surface mounting enclosures (protection type
IP67) are for the purpose of accommodating up to 6
M22-SWD base function elements. The M22-SWD base
function elements are plugged onto an M22-SWD-I1…6-
LP01 printed circuit board, which is inserted into the surface
mounting enclosure. The connection with the SmartWire-DT
network is created via this printed circuit board.
The standard RMQ-Titan surface mounting enclosure
M22-I1 to M22-I6 in conjunction with standard M22 front
elements are used (
“M22-SWD base fixing“, page 63).
Socket/plug switch cabinet bushings
You use switch cabinet bushings with an M18 x 0.75 mm
screw fixing for external connection of the SmartWire-DT
network to a switch cabinet or enclosure.
You use the switch cabinet bushing, for example, to connect
to a control console with M22-SWD… function elements or
to connect to another switch cabinet and in the process to
supply in addition the 24 V DC control voltage for contactors
(
“Switch cabinet bushing“, page 70).
Link for base or front mount
The link for base fixing is used for unused slots in the card
for surface mounting enclosure M22I…
The link for front mounting is used in combination with
unused external device plug. The jumpers must be fitted in
this case, since an address assignment to all SmartWire-DT
stations is not, otherwise, possible.
Network terminator for flat band conductor
The SmartWire-DT network requires termination at the end
of the network (
“Using network termination“, page 93).
Adapter for blade terminal/round cable
This adapter (part no. SWD4-8FRF-10) is for the purpose of
adapting from ribbon cable to round cable and vice versa
(
“Using the ribbon/round cable adapter“, page 92).
www.comoso.com
