SC300 Handbook
68
Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.
IPN 997-00012-03 B2 Issue B2 July 2018
Invert:
-
Trigger:
Level
► To Create an AC Low Smart Alarm
1
Configure a
Smart Alarm
with the following parameter settings:
Name:
AC Low
Operator:
OR
Severity:
Minor (or a different severity if required).
Set other parameters as required (see details on page 62).
2
Configure a
System Values Source
with the following parameter settings:
SA Num:
The number of the
Smart Alarm
configured in step 1.
Status:
Enabled
System Value:
AC Voltage
Threshold Type:
Low
Threshold:
185 (or a different value if required)
Hysteresis:
5 (or a different value if required)
Invert:
-
Trigger:
Level
Batteries
The following information is available about the batteries connected to the dc power system.
on page 73.
Parameter
Description
Where to find:
Battery Charge
State
Charge
- the battery current is above the
Battery
State Threshold.
Discharge -
the battery current is below -1 *
Battery State Threshold.
Float -
the battery current is between ±
Battery
State Threshold.
Unavailable
- the battery current is not
available.
See SC300 or Web displays ??? or N/A on
page 123.
SC300: Battery > Battery
DCTools/Web: Batteries
Battery
Temperature
The temperature measured by the battery
temperature sensor.
Ah Discharged
The current level of battery discharge.
See also Reset Ah Discharged on page 76.
