SC300 Handbook
62
Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.
IPN 997-00012-03 B2 Issue B2 July 2018
Smart Alarm Actions
This section provides a means to view and configure control function actions triggered by Smart
Alarms.
Not all Smart Alarm control in configured in this section. LVD control is configured in the LVD
section.
Smart Alarms may be configured to:
•
Trigger an LVD disconnect
•
Trigger an equalize cycle
•
Trigger Peak Load Reduction (PLR)
•
Shut down all rectifiers
•
Shut down all solar chargers
•
Change voltage control to use
Alternative Float Voltage
rather than
Float Voltage
.
Configuration
Information
The following information is available about
Smart Alarms
and
Sources
.
Parameter
Description
Where to find:
Smart Alarm State The present state of the
Smart Alarm
. If
Enabled
and active, this will be the alarm's
Severity
. If
Dis
abled,
or
Enabled
but inactive, the state is
shown as "-".
DCTools/ Web: Alarms >
Smart Alarms > Smart
Alarm States
Change
The time and date when the Smart Alarm state
changed.
Source Triggered
The present state of the source:
Inactive Clear = The source condition is false and
the alarm is not triggered.
Inactive Armed = The source condition is false
and the smart alarm input is active, because the
source is set to
Invert
.
Active Armed = The source condition is true and
the smart alarm input is active.
Active Clear = The source condition is true, but
the smart alarm input is inactive because the
source is set to
Invert
.
= There is an invalid dependency, or the
source
Index
is invalid.
= The source is part of a circular dependency.
DCTools/ Web: Alarms >
Smart Alarms > Sources
Next Activation
The date and time this schedule will next
activate.
DCTools/ Web: Alarms >
Smart Alarms > Schedule
Sources
Schedule End
The date and time this schedule will activate for
the last time.
