Communications
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
51
6
Press OK.
DCTools/PowerManagerII
will now connect to the SC100.
7
See System Operation on page
for details of the SC100 control and monitoring functions
available via
DCTools
.
For help using DCTools press F1.
8
If required, access to the SC100 via
DCTools
or
PowerManagerII
can be password controlled.
See Write Access Password on page
GSM Modem Communications
Connections
The PC modem may be external to the PC (as shown) or internal.
SC100 system controller
PC/laptop with PowerManagerII and/or DCTools.
RS232 modem cable (straight-thru). If access to
XS1 is restricted use a DB9 ribbon cable extension
(Farnell part number 869-6411).
GSM modem
Modem
Optional:
SMS text capable GSM cell phone
SMS text message "P" or "p"
Power status text messages
Alarm text messages
SC100 Setup
Not all modems are suitable. If your modem does not operate correctly check the modem setup
string. Contact your Eaton dc product supplier or Eaton for further assistance. See Worldwide
Support on page
► To enable modem communications
1
Connect to the SC100 with
DCTools
(see details on page
2
Go to
Communications
.
3
Click on
+
to expand
Modem
. Configure the following settings:
Enable Modem:
Enabled
Modem Power Reset:
Optional. If this is enabled, then the SC100 will attempt
to reset a non-operating modem by turning its power
supply off and on using digital output 2.
Modem Set Up String:
The string sent to the modem on reset.
Summary of Contents for SC100
Page 52: ......
