Eaton RF System 2.42, Manual

Page: 179 / 244

179 Eaton RF-System
© 2015 Eaton Electrical Group
action in a Macro or Scene.
Marker
(Energy
sensor) Energy
sensor
(Energy- and
Power
channel) This Marker has the speciality that
2 channels (Energy and Power)
are created when the Marker is
created. Both channels of the
Marker will be treated like an
Energy sensor in an Energy
function.
Can be programmed with a
complex logic (e.g. Value of a
marker can be the result of a
combination of different analog
values). The following
combinations are possible: PLUS,
MINUS, MIN, MAX, AVERAGE,
MULTIPLIED, DIVIDED). Can also
be used as Event, Condition or
action in a Macro or Scene.
Further information about the configuration of Marker-Logics and Use in Macro & Scene Function
will be available in the SHC Web Admin Console Help.
Connection to generic device channels:
Connections to devices whose type is not specifically supported in the SHC and where the type
cannot be determined correctly when drawing a connection in the MRF will be created as generic
device channels in the Smart Home Controller.
Connections to the following devices are affected:
· Home-Manager (Datapoint 1-99)
· USB-RF-Communication-Stick (Datapoint 1-99)
· old USB-Communication Interface (Datapoint 1-99)
· Routing actuator (all inputs and Output 1-5 for Routing actuator with Logic)
When drawing a connection from the Smart Home Controller only the direction will be set (SHC ->
Device, Device -> SHC) which basically only tells the SHC if it is an Input or an Output.
In the Connection list of the configuration window these connections will be displayed as
'undefined type'. You have to manually set a replacement-type that is supported by the Smart
Home Controller for the connection to be active.
Inputs can be set as Analog inputs or Binary inputs and outputs can be set as Analog output or
Switching actuator. All configuration possibilities of the replacement-type are then available
(Function, Extra option etc.). A name for the connection can also be defined.