Eaton Powerware 225 kVA Three-Phase Power Distribution Unit, Installation And Operation Manual

Page: 56 / 142

PDU OPERATING INSTRUCTIONS
EATON Powerware
®
225 kVA PDU Installation and Operation Manual
S
164201629 Rev D www.powerware.com
6−12
6.2.6 Mimic Screen
Figure 6-9 shows the main menu and mimic screen. To select the mimic screen from
the Events, Meters, Profile, or Setup screens, press the
pushbutton on the
current menu bar.
The mimic screen shows the internal components of the PDU and a real-time
graphical representation of the operating status of the system.
PROFILE
METER EVENTS SETUP
000.0
000.0
000.0
000.0
000.0
000.0
CONTROL
EATON EMS-PDU
Figure 6-9. Main Menu and Mimic Screen with Transformer
6.2.7 Display Menu Operation
Table 6-3 describes the menu functions and and how to use them.
Table 6-3. Display Menu Operation
Function Subfunction Operation
Events Press the EVENTS pushbutton on the main menu to display a listing of all system events that are
currently active. The most recent event is listed first. As events clear, they are removed from the
Active System Events listing. To scroll through the events, press the up or down arrow
pushbuttons on the menu bar.
History Press the HISTORY pushbutton on the Active Events menu bar to display the History Log. The
History Log lists up to 127 system events in chronological order, with the most recent event listed
last (once 127 is reached, the earliest event is overwritten). The end of the log (the most recent
events) is displayed first; scroll upward to view older event listings. To scroll through the events,
press the up or down arrow pushbuttons on the menu bar. To return to the Active Events screen,
press the
EVENTS pushbutton on the menu bar.
Meters
The Meter screens show the PDU input and output meter readings. Press the METER pushbutton
on the main menu bar to display the Meter screens. To switch between the Output and Input
screens, press the
INPUT or OUTPUT pushbutton on the menu bar. To scroll through the meter
screens, press the up or down arrow pushbuttons on the menu bar. The current PDU readings are
displayed in the information area of the screen.
Output RMS
(phase−to−phase) The screen shows the total output voltage, output current (each phase), and frequency being
supplied by the PDU, as well as kVA, kW, neutral and ground currents, and power factor
measurements.