EQUIPMENT INSTALLATION
Eaton 9PXTFMR5, 9PXPPDM2, 9PXTFMR11, and 9PXPPDM1 User's Guide
S
P-164000200 Rev 4
12
Installing the Cabinet
To install the cabinet on the rails:
1.
Do this only if the UPS is already installed and operating:
Shut
down the UPS before installing a 9PX PPDM or 9PX Transformer.
Refer to shutdown instructions in the appropriate 9PX UPS user's
guide for your system configuration.
2.
Place the cabinet on a flat, stable surface with the front of the
cabinet facing you.
3.
Align the mounting brackets with the screw holes on the side of the
cabinet. Install the mounting brackets (see Figure 4).
Rack-mounting
Bracket
Figure 4. Installing Mounting Brackets
4.
Set the rear of the cabinet on the cabinet mounting flanges and
slide the cabinet into the rack (see Figure 5).
Summary of Contents for PowerPass 9PXPPDM1
Page 10: ...INTRODUCTION Eaton 9PXTFMR5 9PXPPDM2 9PXTFMR11 and 9PXPPDM1 User s Guide S P 164000200 Rev 4 4...
Page 12: ...SAFETY Eaton 9PXTFMR5 9PXPPDM2 9PXTFMR11 and 9PXPPDM1 User s Guide S P 164000200 Rev 4 6...
Page 50: ...STARTUP Eaton 9PXTFMR5 9PXPPDM2 9PXTFMR11 and 9PXPPDM1 User s Guide S P 164000200 Rev 4 44...
