Eaton Power Xpert Series, Installation And Operation Manual

Page: 89 / 156

Installing Options and Accessories
Eaton
®
Power Xpert
®
9395C UPS Installation and Operation Manual P-164000821—Rev 01 www.eaton.com/powerquality 5-9
9. Install wiring between the SCM II terminal block TB2 and the monitoring equipment. See Figure 5-6 for
terminal block location and Figure 5-7 for terminal assignments.
10. Close the front door and secure the latch.
11. Restart the UPS. See Chapter 7, “UPS Operating Instructions” for startup instructions.
Figure 5-7. Supervisory Contact Module II TB2
NOTE Setup of the Powerware Hot Sync CAN Bridge Card must be performed by an
authorized Eaton Customer Service Engineer. Contact an Eaton service
representative to schedule a date.
System Normal
No Redundancy
On Generator
Bypass Not Available
On Battery
UPS Alarm
On Bypass
Shutdown Imminent