Eaton Power Xpert Gateway 200E, User & Installation Manual

Page: 61 / 212

CHAPTER 8 - PXG200E CONFIGURATION WEB PAGE
53 EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835
5. Select whether there is a meter associated with the new Main from the
drop-down menu
(Figure 47, A) . Note that the answer determines what
other questions are asked as you are completing the configuration of the
Main. The selections are:
a. Yes (default)
b. No
6. Click on the button (Figure 47, B) if you are satisfied with your
selection.
a. If you selected “Yes” in Step 5 , proceed to Step 8 .
b. If you selected “No” in Step 5 , proceed to Step 11 .
7. Click on the button (Figure 47, C) to go back to Step 1 if you wish
to change the selection.
Figure 47
8. Select the type of meter from the drop-down menu (Figure 48, A) .
Figure 48
9. Click on the button (Figure 48, B) to proceed to Step 11 if you are
satisfied with your selection.
10. Click on the button (Figure 48, C) to go back to Step 1 if you wish
to change the selection.
PXG200E_040
A
B
C
PXG200E_041
A
B
C
RETURN