122
Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 06
Figure 90. System Events Screen
77..33..88
U
Usseerr LLoogg
Select the
User Log
tab from the menu bar on the System Events screen to look at the User Log screen. This
screen shows any currently active alarms, notices, or commands.
•
System Event Horns
– The system event horn beeps to alert an operator that an event needing attention
is taking place. The horn cycles at a half-second rate.
•
System Event Indicators
– The status indicators on the UPS control panel work with the event horn to let
the operator know when the UPS is operating in any mode other than normal. Only the ON indicator is
visible during normal UPS system operation. The other indicators illuminate to indicate alarms or events.
When an alarm occurs, first check these indicators to see what type of event has taken place. For
descriptions of the status indicators, see paragraph
.
•
System Event Messages
– When a system event occurs, a message appears on the LCD in the UPS
status area. This message is also written to the Active Events Log and may be added to the History Log.
The messages are divided into four categories: alarms, notices, status, and commands.
The user log window (
1
) allows the operator to enter any number up to the number shown to the right of the
box. Each window shows five events. The operator can also use the UP/DOWN arrows above and below the
blue field (
2
) showing the number of events in the log. See
Summary of Contents for Power Xpert 9395C
Page 8: ......
Page 175: ...16400082106 164000821 06...
