116
Eaton Power Xpert 9395 UPS Installation and Operation Manual 164201716—Rev 13
77..22..33
U
Ussiinngg tthhee LLC
CD
D aanndd P
Puusshhbbuuttttoonnss
The LCD on the control panel provides an operator interface with the UPS system.
identifies the
display areas discussed in the following sections.
Figure 65. Parts of the LCD
METERS
P
U
T
E
S
S
T
N
E
V
E
ALARM:
INPUT AC UNDER VOLTAGE
OUTPUT
BATT
UPS
INPUT
STSW
A
B
C
D
CONTROLS
LOAD OFF
BYPASS
A
The
UPS status
area automatically scrolls between the Eaton model number, current date and time, active
alarms, active notices, and load percent and battery runtime for the UPS. If the Environmental Monitoring
Probe is installed, the temperature and humidity sensed by the probe will also be displayed. The top line of
display blinks while scrolling when the system needs attention. Some notices and alarms may be accompanied
by an audible horn. To silence the horn, press any control panel pushbutton once. Shown is a typical alarm
message. For more information about alarms and notices, see paragraph
.
B
The
information area
contains data about UPS status and operations.
C
The
menu bar
lists the titles of the available screens. To select a screen, press the pushbutton underneath
the desired screen.
D
The
navigation pushbuttons
function depending on the screen displayed. Use the pushbuttons to select
menu screens or scroll through available screens. The LCD options above the pushbuttons indicate each
pushbutton's function.
You can use the LCD and the pushbuttons to:
•
Look at a log of UPS events (alarms, notices, and commands) (see paragraph
•
Monitor UPS operation (see paragraph
)
•
Set UPS parameters (see paragraph
)
•
Control UPS operation (see paragraphs
and
System Status Screen and Controls
)
After approximately 30 minutes, the display screen darkens. To restore the screen, press any pushbutton
once.
