Eaton Power-Sure 700, Installation And User Manual

Page: 17 / 200

34008097EN/AE
- Page 15
3. Operation
3.1 Start-up and normal operation
UPS personalisation
3.2 Operation on battery power
Transfer to battery power
Low-battery warning
For the initial start, AC power must be present to detect any wiring errors. Subsequently, the UPS can start even if
AC power is not present.
Press button (27) for approximately 1 second.
◗
The buzzer beeps once and all the LEDs go ON simultaneously.
◗
The buzzer then beeps twice during the self-test, then button (27)
remains ON, indicating that the load outputs are supplied.
The connected devices are protected by the UPS.
◗
LED
(20)
is ON.
If LED (22) is ON, a fault has occurred (see the
"
Troubleshooting
"
section).
◗
During normal operation, the scroll button (25) may be used to read
UPS measurements (AC input voltage, operating mode, battery
capacity and UPS serial number).
If UPS personalisation is desired, it is advised to enter the personalisation mode at this time.
This mode may be entered using the buttons on the control panel or the
Personal Solution-Pac software (Windows)
included on the Solution-Pac CD-ROM provided by EATON.
◗
The connected devices continue to be supplied by the UPS when AC
power is no longer available. The necessary energy is provided by
the battery.
◗
LEDs (20) and (21) go ON.
◗
The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
The display indicates the remaining backup time.
◗
LEDs (20) and (21) go ON.
◗
The audio alarm beeps every three seconds.
The remaining battery power is low.
Shut down all applications on the connected equipment because
automatic UPS shutdown is imminent.
20
27
22
21
25
ESC
20
21
ESC
20
21
ESC
34008097EN_AE.fm Page 15 Lundi, 1. décembre 2008 4:31 16