Eaton PDI WaveStar, Setup And Operation Manual

Page: 27 / 68

Eaton PDI WaveStar Color Monitor Setup and Operation Manual P-164001109—Rev 01 17
Figure 13. Modbus RTU Setup
On SETUP screen, touch DEVICES/MODBUS
The
DEVICES/MODBUS
screen defines the Modbus
network and device chain as well as set the banner
name for the header.
Modbus Device Chain:
Banner
Name displayed on top line.
Number of Devices
should equal
number of devices connected in
Monitor’s downstream device chain.
Upstream Modbus:
Address of Monitor on upstream side
Baud rate (9600/19200/38400)
Parity (even/odd/none)
Downstream Modbus Network
characteristics are fixed and cannot
currently be modified.
44..22..22 M Mooddbbuuss R RTTU U S Seettuupp
Downstream Modbus settings cannot be changed.
Upstream Modbus provides network characteristics on the upstream side of the Monitor.
• Address is the address that the upstream Modbus client, such as the Building Management System
(BMS), uses to address the Monitor. The downstream device addresses are incremented sequentially
from this address. So if the Monitor has address 20, the next three devices will appear 21, 22, and 23 to
the upstream client device. (See
Figure 10 , “Modbus Addressing”.)
• Upstream Modbus settings for Baud rate and Parity must match those for the upstream Modbus client.
44..22..33 TTC CP P//IIP P aanndd M Mooddbbuuss TTC CP P//IIP P S Seettuupp
For TCP/IP, the customer must provide an Ethernet cable connected to the Ethernet port (RJ45 header J11) on
the Monitor. (See
Figure 4 , "Color Monitor Network Connections".)
On the SETUP screen, touch NETWORK/SNMP to display the network parameters for TCP/IP (11, 14).
The following must be specified for Modbus TCP/IP:
• IP Address
• Subnet Mask
• Gateway
Each connected monitor must be assigned a unique address. DHCP is not supported.
Setup: Monitor and Network