Eaton PDI WaveStar, Setup And Operation Manual

Page: 25 / 68

Eaton PDI WaveStar Color Monitor Setup and Operation Manual P-164001109—Rev 01 15
C Chhaapptteerr 44 S Seettuupp:: M Moonniittoorr aanndd N Neettw woorrkk
You set configuration parameters and other information for the Color Monitor in three ways:
• The SETUP screen has system parameters, such as banner name, password, and network addresses.
• Device SETTINGS screens let you set device names, specific device configurations, and software
versions for each BCMS device in the Monitor’s chain. (See Chapter 5 Device Chain: Settings .)
• The SOFTWARE VERSIONS screen lets you add the model information for the unit mounting the Color
Monitor.
44..11 S SEETTU UP P:: M Miisscceellllaanneeoouuss P Paarraam meetteerrss
Touch SETUP to display buttons for several configuration items (see Figure 11 ).
A password is required to access and change setup parameters. Enter the password (default is "PDI"). The user
can navigate through any of the screens and come back to
SETUP without having to re-enter the password for
10 minutes. Touch PASSWORD to change to a new password.
Figure 11. SETUP Screen
Touch buttons in the initial
SETUP
screen
to link to miscellaneous setup functions:
PASSWORD : Keyboard appears, enter
password, then type new password.
HORN DISABLED : Toggle Monitor’s audible
alarm to ENABLED/DISABLED.
BANNER
: Banner setup (here shown as
“Eaton DISPLAY”) is on same screen as
Modbus setup.
TIME & DATE : Set time and date; used on
HOME screen and alarm timestamps.
CALIBRATE GUI
: See next figure.
See 4.2 Network Setup