Eaton PDI WaveStar BCMS, Installation And Operation Manual

Page: 40 / 54

32 Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01
55..33 V Viieew wiinngg D Deevviiccee IInnffoorrm maattiioonn
The BCMS Hub displays formatted information from each device’s points list.
To view device information, highlight the device line on the Home screen (by touching the line or scrolling to it)
and touch Go . The first screen for that device appears. Device screens form a looped chain. Touching More or
Next on a device screen advances to the next screen in the loop.
Using controls requires user login with correct authorization. If you attempt to use a control without correct
authorization, the Voice Response Unit will state, “You do not have access to this function.”
55..44 C Clleeaarriinngg A Allaarrm mss aanndd W Waarrnniinnggss
Alarms and warnings must be cleared from device screens. Alarms cannot be cleared individually. All alarms
and warnings for a device are cleared together.
55..55 B Buuss S Syysstteem m D Deevviiccee IInnffoorrm maattiioonn
55..55..11 EEnndd FFeeeedd
End Feed BCMS screens are the same for PowerWave Bus Systems™, PowerWave 2™ Bus Systems, and
PowerWave Silver™ Bus Systems. Point values in the End Feed screens correspond to point values in the End
Feed
PM Input Board points list.
The first screen to display is the End Feed Summary . Device screens form a loop: touch More on each screen
to cycle through the screen loop, returning to End Feed Summary ( Figure 23 and Figure 24 ).
Figure 23. End Feed Summary Screen
If a control is not present for a desired operation, you can use the Manual control to set the register value for a
point.
Operation: Device Information