![background image](http://html1.mh-extra.com/html/eaton/moeller-mfd-80/moeller-mfd-80_hardware-and-engineering_525672010.webp)
About the Display/Operator
System
6
05/08 AWB2528-1611en
Task
The display/operator system enables you to externally imple-
ment display and operator functions for a connected PLC. If
the PLC is mounted in a control cabinet, for example, the
display/operator unit can be installed in the control cabinet
door to provide the following display and operator functions.
Display functions
• Basic screens (preconfigured display screens)
During initialization, the display can be loaded with up to 64
basic pages (preconfigured display pages/screens). These
basic pages are selected during operation. Each basic page
provides space for up to 4 variables. The variables can be
displayed and edited.
Instead of embedding variables, the basic page can also be
run in scrolling mode. In this mode you can add lines to any
position in the basic page. Existing lines are overwritten or
moved up or down, depending on the setting.
The basic pages 1 to 62 are stored retentively on the display.
j
Danger!
The display/operator system must only be run if it is prop-
erly mounted and installed:
• The installation must comply with regulations for elec-
tromagnetic compatibility (EMC).
• MFD-CP4-CO is designed to be installed in an enclo-
sure, switch cabinet or distribution board.
• If the display/operator system is switched on, the
controlled devices should not respond in an uncon-
trolled manner, e.g. uncontrolled motor startups.
Summary of Contents for Moeller MFD-80
Page 14: ...10 05 08 AWB2528 1611en...
Page 38: ...34 05 08 AWB2528 1611en...