Eaton Ferrups FX UPS P-164000906 Eaton Ferrups FX User’s Guide P-164000906—Rev 05
61
Use this key:
To do this:
[0]
Pause the scrolling and start it again.
[1]
Go to the next log entry.
The RCD will also display the active alarm information on the top line of the display.
1100..33
S
Siilleenncciinngg tthhee A
Allaarrm
m
When an alarm condition is displayed via the Remote Control Display a alarm tone is emitted. The alarm tone can be silenced
for present or future alarms or can be silenced temporarily until a new alarm becomes is set to a active state.
To silence the alarm beeper for present or future alarms press the following buttons on the Remote Control
Display:
•
Press [ CONTROL ].
•
Press the number [5]
•
Press the [ENTER] button
•
Press the [ENTER] button
To silence the alarm temporarily until a new alarm becomes active press the following buttons on the Remote
Control Display:
•
Press [ CONTROL ].
•
Press the [.] button
1100..44
D
Deetteeccttiinngg aann A
Allaarrm
m C
Coonnddiittiioonn
When the Eaton FERRUPS FX UPS detects an alarm condition, the UPS displays the alarm. The ALARM indicator on the
remote control display illuminates and sounds an audible alarm. This section describes important troubleshooting steps you can
take to help diagnose and silence typical alarms and conditions.
The UPS displays the alarm with the following indications:
•
The lightbar on the remote control display will illuminate red.
•
The UPS will sound an audible alarm.
•
The remote control display will display the alarm message.
All active alarm conditions can be viewed one of three ways:
