For more information visit:
www.EatonElectrical.com
Inside EZD
MN05013005E
390
Delay times for inputs and
outputs
The time from reading the inputs and outputs to switching
contacts in the circuit diagram can be set in EZD via the delay
time.
This function is useful, for example, in order to ensure a clean
switching signal despite contact bounce.
Figure 189: EZD input assigned a switch
J
Only use as much retentive data as is actually required.
The screen with the largest memory requirement reduces
the memory available for the program. Several smaller
screens allow more space for the program.
Use as small pictures as possible with 1 bit gray-scale. The
pictures should normally be 32 x 32 pixels in size in order to
fully utilize the optimum brilliance of the display.
S1
0V
I1
