For more information visit:
www.EatonElectrical.com
Commissioning
MN05013005E
96
Configuring an EZ-NET
network
If you want to work with the EZ-NET network and
communicate with several stations, the network must be
configured first.
Proceed as follows:
Connect all network stations. EZ-NET socket 2
K
to EZ-NET
socket 1
L
.
X
The first station 1 (socket 1
L
) and the last station
(socket 2
K
) must be provided with a network termination
resistor
.
X
Connect all stations to the power supply.
Figure 73: Example topology with two EZ-NET stations
Network termination resistor
Physical location
Station number
X
Switch on the power supply on all stations.
X
Ensure that all stations have a power supply. The POW
LED must light up or flash. It is only possible to configure
the stations which have an active power supply.
X
Proceed to the first physical station (Location 1). This
station has the termination resistor inserted on socket 1.
2
1
1
2
I1 – I12
Q1 – Q6
R1 – R12
S1 – S8
