![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operation-manual_524480129.webp)
Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
121
6.
Choose one of the following security levels to be applied to the SNMPv3 user:
l
Not Set
: the SNMPv3 user is not configured and therefore disabled.
l
Auth Priv:
an authentication password and a privacy key are required to access the MIB objects.
l
Auth No Priv
: an authentication password but no privacy key are required to access the MIB objects.
l
No Auth No Priv
: no authentication password or privacy key are required to access the MIB objects.
7.
Type the authentication password (if required by security level), with 8 to 24 characters allowed.
8.
Type the privacy key (if required by security level), with 8 to 24 characters allowed.
9.
Click
Save
. Otherwise, click
Cancel
to return to the SNMP Settings page.
Access Eaton ePDU MIB Objects (Privileged Access Only)
1.
Access the Web interface and log in.
2.
Under Network, select SNMP. The SNMP Settings page displays.
3.
Click
Link to the ePDU Mib
.
Security
Enable/Disable SSL Encryption
1.
Access the Web interface and log in.
2.
Under Network and Security, select Global. The Security page displays.
3.
In the Ports Settings panel, ensure that the
HTTP Enable
check box is checked and that the associated
HTTP Port number displays.
4.
Check the
Force SSL
check box to enable SSL encryption, or uncheck the box to disable it. If enabled, the
HTTPS Port entry box is active. Type the port number.
5.
Click
Save
.
6.
Open the System submenu in the Settings menu. In the Network Management Card panel, click
Restart
network management card
to restart the ePDU Network Management and Control (eNMC) module.
NOTE
With SSL encryption, the Web interface is accessible from
https://<IPv4 address>
and / or
https://[IPv6 address]
according to the IP configuration.
NOTE
When
Force SSL
is selected, the Web page is only available through HTTPS. If you
enter the IP address through HTTP, it will be automatically redirected to HTTPS and
you will receive the following message and a new URL link:
The Network Management Card is protected by SSL encryption.
Please use the following address(es) to connect to the Network
Management Card. https://166.99.224.82