![background image](http://html.mh-extra.com/html/eaton/epdu-g3/epdu-g3_operation-manual_524480123.webp)
Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
115
4.
To select and store an eNMC module configuration file to be used during an upgrade, use
Browse
to
review and select the configuration file.
NOTE
When uploading a file, you cannot write the file path in the text field. You must
select the file from the file explorer window that displays when you click
Browse.
5.
Click either
Upload
or
Download Configuration
and a message is provided to tell you if the file uploaded
successfully or failed to upload:
l
Upload
: Gets the list of the ePDU XML parameters from a file selected by the browser and sends it to
the ePDU.
l
Download Configuration
: Stores a list of the ePDU XML parameters in a file selected by the browser.
6.
To restore the eNMC module to factory defaults, click
Restore Factory to default settings
. A pop-up
confirmation message displays:
Are you sure you want to restore the factory default settings of the Network
Management Card?
Note: This will NOT restart the ePDU or change the power status of the outlets.
Perform Firmware Upgrade
NOTE
A firmware upgrade can only be performed by a SuperUser. This upgrades the
firmware and the Web page. The Web interface will not be available during the
upgrade.
1.
Access the Web interface and log in.
2.
Under Settings, select System. The System Settings page displays.
3.
In the Network Management Card panel, ensure the firmware upgrade functionality is enabled and that
the upgrade file has been downloaded.
4.
To upgrade the communications module, click
Upgrade network management card
. The upgrade is
launched immediately
.
5.
Click
Restart network management card
.
6.
When the upload of the image file completes, the following message displays:
Your file was correctly uploaded.
Please wait about three minutes while the image writes to your flash device,
then click the browser refresh button.
Click OK to restart the card and begin the upgrade of the firmware.
ePDU Configuration
1.
Access the Web interface and log in.
2.
Under Settings, select System. The System Settings page displays.
3.
Ensure that the Device Administrator Contact Name and the Device location have been typed in the text
boxes.