Warning -
Intellectual Property Rights
Eaton wishes to make it clear that it owns intellectual property rights in the
product which it manufactures (whether or not listed in this leaflet) and that it
will take legal action against any party found to be manufacturing, using, or
selling any article which infringes the company’s intellectual property. All
marks in this document identified with an R symbol or a TM symbol adjacent
to the mark are trademarks of Eaton.
© 2019 Eaton Electric Limited.
All rights reserved. www.eaton.com/recycling
The use to which this product is put and its place of installation is outside our
control. Particular care should therefore be taken to follow the instructions
given here and to ensure their continued availability in conjunction with the
use of the product.
No responsibility can be accepted by us if these instructions are disregarded.
Further copies of these instructions and information concerning the
installation and proper use of this product can be obtained by contacting the:
Technical Services Department
Eaton Electric Limited, Middleton, Manchester, M24 1GQ.
Tel: +44(0)8700 545 333,
email: [email protected]
M8 Cable Lug – 4 Qty
rating as required
M12 Contained Palm Width
MCCB Cable Lug – 4 Qty
M12 required for additional
palm length.
M12 Cable Lug – 4 Qty
M12 required for
additional palm length.
Refer to main installation leaflet for additional fitting details (LT1222 400A -EM4PBK404, EM4PBK404M and LT1223 800A – EM4PBK804, EM4PBK804M)
31mm
16mm
400A INCOMER METER KIT - EM4PBK404M
Fit the ‘Live Side Connectors’ on top of the incoming M12 cable lugs
and screw down onto the CT extension palms. Connect the Exel double
insulated feed cables to the ‘Live side connectors’ using M8 cable lugs.
400A INCOMER KIT - EM4PBK404
Fit the ‘Live Side Connectors’ on top of the incoming M12 cable lugs
and screw down onto the MCCB terminal. Connect the Exel double
insulated feed cables to the ‘Live side connectors’ using M8 cable lugs.
800A INCOMER KIT - EM4PBK804
Fit the ‘Live Side Connectors’ on top of the incoming M12 cable lugs
and screw down onto the extension palms. Connect the Exel double
insulated feed cables to the ‘Live side connectors’ using M8 cable lugs.
800A INCOMER METER KIT - EM4PBK804M
Fit the ‘Live Side Connectors’ on top of the incoming M12 cable lugs
and screw down onto the CT extension palms. Connect the Exel double
insulated feed cables to the ‘Live side connectors’ using M8 cable lugs.
M12 Cable Lug
– 8 Qty
16mm
Live Side
Connector
Live Side
Connector
Live Side
Connector
M8 Cable Lug – 4 Qty
rating as required
M8 Cable Lug – 4 Qty
rating as required
Feed to
Exel
Feed to
Exel
Feed to
Exel
Feed to
Exel
15Nm
31Nm
31Nm
31Nm
15Nm
46Nm
46Nm
15Nm
M12 Cable Lug
– 8 Qty
Live Side
Connector
15Nm
M8 Cable Lug – 4 Qty
rating as required
16mm
16mm
