Eaton easySafety, Manual

Page: 161 / 695

Working with function blocks
157
02/16 MN05013001Z EN
Adding function blocks to the circuit diagram for the
first time
You can add a standard or safety function block to the
standard or safety circuit diagram in the following way:
X
Use the
ÍÚú í
buttons to move the cursor to a free
contact or coil field.
X
Press OK so that the easySafety device switches to entry
mode.
When editing the safety circuit diagram you have to enter
the M password before this change if the device has not
been unlocked (
a
page 571).
X
Then use cursor buttons
ÍÚ
to select the required
function block, e.g. safety timing relay using the TS
identifier.
X
When the function block identifier flashes, press OK or the
cursor button
í
to move to the function block number and
press OK.
The parameter dialog opens. In this dialog you can assign all
the parameters for a safety function block. You can only set
Boolean parameters here for the standard function blocks.
The entire parameterisation is carried out in the function
block editor. Further information on this is provided in the
following chapter.
L: 1 C:1 B:7520
TS01QS
L: 1 C:1 B:7520
TS01QS
L: 1 C:1 B:7520