Eaton easyControl EC4-200, User Manual

Page: 63 / 113

10/10 MN05003003Z-EN
59
10 Browser commands
The PLC browser is a text based control monitor. This is where you
enter commands in the entry line for scanning PLC status from the
PLC. They are sent as strings to the PLC. A results window of the
browser displays the response. This allows you to carry out
diagnostics or debugging tasks.
To run these commands:
X
Double-click Resources and then PLC Browser in the
programming software.
A new window called PLC Browser will appear in the field on the
right.
X
Click the button .
The selection field lists the available browser commands.
X
Double-click the required command to select it.
The selected command now appears in the “PLC Browser”
window.
X
Press the enter button in order to view the response of the PLC
to the browser command in the event window.
The controller supports the browser commands from table 13.
Setting Ethernet parameters
If you use a browser command to set the IP address/subnet mask
or gateway address, this is not active until the following steps have
been completed:
• Switch the device off and on
• Enter the “reboot” command
• Unplug and replug the Ethernet cable on the EC4-200.
Table 13: Browser commands
h
The browser commands can only be used online.
h
Further information on the selected Browser command
can be obtained by entering a “?” followed by a space in
front of the selected browser command and then pressing
Enter.
The commands are also described in chapter “Resources
l
PLC Browser” in the manual on the programming
software (MN05010003Z-EN).
? Get a list of implemented commends.
pinf Output project information
cycle Output cycle time
canload
*
Display load of CAN bus
copyprojtommc Copy the current boot project to the memory
card
createstartupini Generate the Startup.INI file on the memory
card
factoryset Activate factory settings
format Format memory card
GetNodeId Display the CANopen Node ID of the CAN
interface
GetRoutingId Display of the routing Node ID and the routing
interface
getipgateway Display of the set gateway address
(Default address: 0.0.0.0)
getipconfig Display of set IP address and subnet mask
Display of default values:
IP address: 192.168.119.60
Subnet mask: 255.255.255.0
getmacaddress Display of the MAC address of the
Ethernetcontroller. Display e. g. 00-80-99-05-
11-22
getrtc Read real-time clock
metrics Output PLC information
reboot Reboot of EC4-200
h
Execution is carried out immediately,
i.e. without a prompt, after the
command is confirmed.
reload Load boot project from FLASH to PLC
remove Delete boot project in the FLASH
removeprojfrommmc Delete boot project and Startup.INI file on the
memory card
removestartupini Delete the Startup.INI file on the memory card
setipconfig Setting the IP address and subnet mask
Syntax (example): setipconfig 192.168.119.60
255.255.255.0 -> ok or error message
setipgateway Setting the Gateway address
Syntax (example): setipconfig 192.168.119.10
-> ok or error message
setrtc
*
Set real-time clock
Further information concerning the commands marked with *
can be found in the following pages.