10
12345
12345
12345
12345
12345
12345
12345
Programming Parameters
Programming customizes the DPMs functions to fit the application. All program-
ming may be done by using the front panel program (
PGM
) and arrow keys - up
(
), down (
), and right (
) Programming is done by entering the proper
value into each programming parameter. The parameters each have a name and a
value, and are shown in the program list starting on page 12. The programming
parameters associated with the optional RS485 communications board, the analog
retransmission board, and the relay output board only show in the program list if the
corresponding option board is installed in the DPM.
To navigate through the parameter list, use the program, up, and down arrow keys.
1. The parameter name is displayed by pressing and holding the program key
(
PGM
).
2. The value of the parameter is displayed by releasing the program key.
3. While holding the program key (
PGM
), the unit scrolls down one parameter
name each time the down arrow (
) key is pressed, and scrolls up one
parameter name each time the up arrow (
) key is pressed. When the
PGM
key is released, the display shows the value of the selected parameter.
To change the value of the selected parameter:
1. Press the right arrow key (
); something on the display will begin to flash
(this could be a single digit, the decimal point, or the entire display).
Durant
PROGRAMMING cont.
