34
Modicon Communication Driver Manual
Switch Settings
The following is a summary of the necessary settings for each of the modules. Be sure to check with
Cutler-Hammer Support Services for any possible updates or changes if you encounter any difficulty.
Operator Station
The Operator Station has one switch setting that is used to set the network node address. The
dipswitch is located on the right side of the unit, above the 9-pin Modbus Plus port. The Operator
Station node address must not be the same as any other node address on the immediate network
Note:
The dipswitch on the dual cabled Modbus Plus Interface board is located at the rear of the
board.
984-385, 984-484, 984-685, 984-785, Compact 984-145, 984-385E, 984-485E,
984-685E,984-785E, and Quantum
The 984-385,-485,-685,-785, and Compact 984-145 models have a switch setting for configuring the
node address. .
In the example below, switch 1 and 2 are up making the address 4. It’s in binary format starting at 1.
Meaning, you must always add 1 to the binary number. (3+1=4)
Card dip switch
1 2 3 4 5 6 7 8
In the example above up=on, down=off, and white represents the switch head.
Summary of Contents for Cutler-Hammer PanelMate Modicon
Page 3: ......
