![background image](http://html1.mh-extra.com/html/eaton/cooper-power-systems-lcr-6200-rfn/cooper-power-systems-lcr-6200-rfn_instructional-leaflet_3969360006.webp)
6
Instructional Leaflet
LCR 6200 Radio Frequency Load Control Switch (Brazil)
LCR 6200 RFN LEDs
LCR LEDs
The three LCR LEDs have the following meanings:
Load Status (Red)
•
LED Off
– LED is off when the load is not being
controlled.
•
LED On
– LED is on when the relay is activated
and the load is being controlled.
On-Board Radio Status (Green)
•
LED Off
– LED is off during normal operation when
an RF SelectCom module is installed.
•
LED Blink On Startup
– LED blinks three times on
a successful startup and the LCR executes a 50%
duty cycle for 6 seconds.
RF Radio Status (Yellow)
•
LED On
– LED is on solid when the RF SelectCom
module has sent a valid ExpressCom message to
the LCR board.
•
LED Slow Blink
– LED blinks slowly if a valid
ExpressCom message has not been received
from the RF SelectCom module in more than 2
hours.
RF SelectCom LEDs
The two RF SelectCom Module LEDs have the
following meanings:
Status (Blue)
•
LED On During Startup
– LED is on solid for 30
seconds during startup, then it turns off.
•
LED On
– LED is on solid when an RF radio
message is being transmitted or received in a
connection.
NOTE:
The blue LED is
not
illuminated when a
broadcast message is being received.
Status (Green)
•
LED Off
– LED is off when the RF SelectCom
module has lost power or when the RF SelectCom
firmware has malfunctioned.
•
LED On
– LED is on solid when the RF SelectCom
firmware has malfunctioned.
•
LED Blinking
– LED blinks (1/2 second on and 1/2
second off) when the RF SelectCom module has
power and it is functioning normally.